Description
A solid altar to perform rituals, a pulpit to preach the sermons, hard pews for the pious masses and soft chairs for clergy administrators.
To build the Chapel as pictured you will require pieces from other sets including Rustic Stone Floors, Rustic Stone and Wood Stairs, Schist Walls, Tudor Walls, Clorehaven Chapel Expansion and Clip Cap sets. To assemble the Chapel and other buildings of Clorehaven you can download the Assembly Guides.
Notes:
- Right-click on the image below and “Save As” to download the reference sheet for this pack.
- Product measurements can be found in the image gallery.
brian.mike.allen (verified owner) –
can the Pew be printed without supports?
Sam Campbell (verified owner) –
Yes the pew can be printed without supports, there is a little bit of stinging that can be removed easily with a craft knife.
jamiep.white (verified owner) –
The pew is prone to failure during printing. I printed two batches of pews, the first batch 3 of 6 failed during printing and the second batch 4 of 4 failed. All seem to have failed due to adhesion failure to the bed likely caused by stray filament floating around from stringing. I was using a Prusa MK3S with black Inland PLA filament printed at 215C and a .2 mm layer height. The other parts all printed fine. Can you add a version of the pew with bigger feet?
Sam Campbell (verified owner) –
If you’re using a Prusa, adhesion issues can be helped with printing on a raft or with a brim and printing at the recommended print settings of 0.1. These were test printed on both Creality Ender 3 and Prusa i3 Mk3.
jamiep.white (verified owner) –
Switched to using a brim and printed at .1 mm height, 4 of 4 were good. Thank you