Shop

Rampage Heavy Wall Door

$7.95

The Rampage Heavy Wall Door is designed to be used as either fixed grating or a door. The door will clip into the door frame once the grating is removed. The grating will also act as a support for printing the door frame.

Please increase your fill density to a least 20% for add strength for the A, C and D components.

Please download the base file set to get the OpenLOCK Clip.

This product is delivered as a .ZIP file pack containing STL files for use on a home 3D Printer. The files are set to 28mm scale but can be rescaled before printing.

Available: In stock
If you are a Kickstarter backer you must login to access your pledge

Description

Updates:

  • 1.1 Now includes frames without gratings

Notes:

  • Rampage is a modular interconnecting scenery building system that allows you to build everything from perfect dungeon tiles to large buildings and fortifications.
  • Rampage is a modular interconnecting scenery building system that allows you to build everything from perfect dungeon tiles to large buildings and fortifications.
  • Rampage uses ‘OpenLOCK’ locking clips to attach the walls to floors so you can mix and match to make amazing combinations. The walls tessellate perfectly allowing you to make true form tiles, rooms and buildings.
  • Right-click on the image below and “Save As” to download the reference sheet for this pack.
  • Please also get the locking clips from the base pack here.

dungeon-tile-rpg-heavy-wall-door

Save

Save

Save

Save

Save

Save

Save

Save

Save

Save

Additional information

File Type

STL files in ZIP folder

Infill

10% to 15% for most parts but increase to 20% for thin upright parts such as door frames for added strength

Layer Height

.2 for Normal Quality .1 for High Quality (.2 Layer height is recommended)

Print Volume

100mm x 100mm x 100mm print build volume required

Supports

Prints without Supports

Q&A

  1. mercmmm (verified owner)

    The doors only connect on one side?

    • Matthew Barker

      Yes the walls only connect on one side

  2. Skip Stephenson (verified owner)

    Will there be a future addition of an “S” type tile for this door?
    I’ve had better success printing this door than the heavy doors, and being able to fit one of these in the middle of a dungeon hall would be quite nice. So far I’m getting a 1 out of 5 success ratio for the heavy doors printing in the frame, they have a tendency to break off at the bottom pin so I have to glue them or toss them as fails.

    • Matt Barker

      Have you tried the other doors now that they have been updated?

Add a Question