Cart (0)

Product Categories+

The Sentient Trees – Hagglethorn Hollow

$19.95

Any sales taxes will be calculated in the checkout.

The Sentient Trees are a set of 6 3d printable trees designed for RPGs and Tabletop Wargaming. There are 3 trees, each has a dormant and awakened pose. They make great companions to the Tree Creatures and Ancient Ruins of Hagglethorn Hollow.

If you are a Kickstarter backer you must login to access your pledge

This product is delivered as a .ZIP file pack containing 3d printer files (STL files) for use on a home 3D Printer.

Description

When a traveller enters the Wandering Woods that border Hagglethorn Hollow, it’s not uncommon for them to see faces in the old gnarled trees. However, if the twisted knots of root and bark open to reveal staring eyes and a mouth that begins to speak, they have very likely stumbled upon one of many sentient trees of the Wandering Woods.

Each tree comes with three different folders for printing options:

  • Main Folder- A folder containing the model cut into pieces for most conventional FDM 3D printers with a print bed size of 200mm x 200mm x 200mm
  • Small Printer Cuts- A further cut version of the model for smaller printers with a print bed size of 120mm x 120mm x 120mm
  • Resin Pre-Supports- Small printer cuts with pre-generated supports for resin printing.

Notes:

  • Right-click on the image below and “Save As” to download the reference sheet for this pack.
  • Small printer reference sheet is included in zip file.
  • Product measurements can be found in the image gallery.
  • Copyright Printable Scenery under license from Tabletop Troubadour Games
  • First Published version 1.4

Additional information

Infill

10% to 15% for most parts but increase to 20% for thin upright parts such as door frames for added strength

Layer Height

.2 for Normal Quality .1 for High Quality (.2 Layer height is recommended)

Supports

pre-support version included in download., Prints without Supports

4 questions for The Sentient Trees – Hagglethorn Hollow

  1. David Byrne (verified owner)

    Hi, I dont see a folder “Main Folder- A folder containing the model cut into pieces for most conventional FDM 3D printers with a print bed size of 200mm x 200mm x 200mm”

    There is a small printer cuts. I am assuming this is the same?

    • Mike (Printable Scenery) (verified owner)

      Hi David,

      The main folder for each one is the first set of files you see when you open the download for each tree, because they fit on a 200mm x 200mm print bed uncut that is how they are presented in the main folder. Hope that clears it up a bit

  2. David Byrne (verified owner)

    Hi Mike, Thanks for the quick answer. Actually will it print uncut? I am fairly new to 3D printing, but looking at those branches I thought they would need supports?

    • Mike (Printable Scenery) (verified owner)

      If youre printing in resin and they’ll fit on the build plate then I’d go for the uncut version (adding supports in your slicer as you normally would) in the main folder.
      If its FDM then the small printer cuts would be recommended, the branches you could add supports to and assemble once printed.

      Hope that helps 🙂

  3. Dungeon Artifacts (verified owner)

    Hello! Was going to print the Hens Son piece in the Asleep pose in resin and noticed a pocket near the bottom of the piece. It looks to be almost right on the opposite side from the face. It looks to be bordered in part by some of the grass.

  4. Matt Barker

    Ok, let me check that model

Add a question
©2024 Printable Scenery. Website by Vienna & Bailey