22 Stretch goals unlocked in the first few days
Thanks for supporting us. The campaign has started well, with 22 stretch goals unlocked so far.
We are busy drawing up more stretch goals, and thanks to your suggestions, we have a bunch more to add to the campaign this week.
Here is the list of ideas we have compiled from suggestions we have so far:
- Alternate Crenulations Ruined and Non-Ruined – Currently Drawing
- Tents in medieval/Middle Ages style.
- Small Stables – Currently Drawing
- Tipping Cauldrons
- Large Drawbridge and Large Gatehouse – Currently drawing
- Bridge system
- Bridges between the buildings on the upper floors – Currently Drawing
- Wash House
- Jousting arena
- Taller towers
- Gargoyles
- Climbing Ivy
- Clip-on Hoardings
- Wall T Sections
- Double Width Battlements – maybe a clip-on system to 50mm wide
- Latrines
- Large Banquet Hall
- Chapple
- Small end towers
- River entrance – Currently drawing
We cannot guarantee that we will be able to add all the suggestions to the stretch goals, but we will give it a go. The more customers join the campaign, the more models we can make.
Thanks for supporting us
Matt and the team at Printable Scenery
I’d pay for most of these even if they weren’t unlocked 🙂 gona need alot more filament
Plus one for the climbing ivy ?, clipon or as a cover instead of a buttress
I’ve already started printing and am very happy with the results. They go very well with the King and Country models. I’d like to add an additional idea: A clip on wall end that will allow one of the SystemHex walls to butt up against one of the King and Country walls without a noticeable gap. Something similar to the bottom step on the wall steps (HEX-Bottom-Castle-Low-Steps-Down).
Also, have you considered a brief assembly instruction set that shows how the various models can interact with each other? It’s clear that you intended the Square Bastion to be able to mate up to the Gate but I’m have a hard time visualizing what pieces would be needed to make that happen.
Yes we can do some videos this week showing how to connect the different components
We do that the Norman Fort wall adapters that have been added to the Norman Fort wall pack.
Fantastic! I have one printing right now as I type this. I saw a comment on the FB thread this morning, raised an eyebrow and said “what’s this?!? woot!” Really digging this set. Thanks for doing it!