Name: Soul Burners
Brand: Age of Sigmar
Availability: InStock

Description

Especially cruel warlocks and necromancers will trap the souls of their foes within these pyres and subject them to a painful drawn-out, fiery end.

Updates:

14 June 2017 (version 1.2) Small mesh repair E-Candle-Brazier-Crypt-v1.2-A, Soulburner-Crypt-v1.0-B.

Notes for Soul Burners:

- Right-click on the image below and “Save As” to download the reference sheet for this pack.
- Product measurements can be found in the image gallery.
- For the clip-together version, download the Rampage Base Pack for free to get the latest version of the OpenLOCK clip.

Additional information

Recommended Printer	FDM or resin printer
Infill	100% for resin printing, 10% to 15% for most parts but increase to 20% for thin upright parts such as door frames for added strength
Supports	requires supports for resin printing, Prints without Supports
Layer Height	0.05 high quality on resin printers, .1 high quality
Scale	28mm Wargames

Use this tool to find the percentage needed to scale your model up or down when printing.
The highlighted row shows the model's current scale and other rows show what percentage to print at to reach that scale.
To set a custom scale, use the calculator in the bottom row.

Name	Millimeters mm	Ratio	Scale %
10mm Wargames & N Scale	10	1:159	35.7%
15mm Wargames	15	1:116	53.6%
HO Scale	20	1:87	71.4%
OO Scale	22	1:76	78.6%
28mm Wargames	28	1:62	100.0%
32mm Heroic & OpenLOCK	32	1:54	114.3%
			-

mm is the height based on the measurement from the bottom of the feet to the eye height of the average human
Height is not the same as Base Size (A 28mm miniature will often have a 25mm round base)

Comments

Warren Sistrom (verified owner) – April 24, 2017

Can you please make variations with different size holes for the tea lights. I am not sure what a “standard size” tea light but every one I have been able to find is a little too big to fit in the hole. Just another mm or 2 all around the hole would be plenty. I could resize up a couple of percent but that will mean that it would also enlarge the tile so it won’t fit in with rest of rampage tiles.
Eric (verified owner) – August 31, 2017

same problem than Warren Sistrom. My tea light is a little too big to fit in the hole.
- Matt Barker (verified owner) – August 31, 2017
  
  I based it on the standard tea light candle holder if it’s too tight, you can increase the size by 1%.
  
  Also, if your printer is printing a wall thicker than 100% then it won’t fit.