Cart (0)

Bed wandered off while printing Rickety Bridges

  • Author
    Posts
    • #264231
      Avatardavidsmdixon1
      Participant

      So I am on an Ender-3 and I was printing the 3” Rickety Bridge when my nozzle wandered off to the upper left Quad and preceding to melt my bed heater connector, this isn’t the only odd Quad placement that these have done

    • #264251
      AvatarNicholas Jebson
      Participant

      Hey David. That seems like a very odd thing to have happened while printing that set, as we have not had any other issues with them. What slicer and settings are you using, Cura?

Viewing 1 reply thread
  • The forum ‘Resolving 3D Printing Problems’ is closed to new topics and replies.
©2022 Printable Scenery. Website by Vienna & Bailey