The Ithillian Sky Port is made of a number of pieces, which are designed to be assembled as individual sections before being glued together as one piece. Assembling the base level For this section, you will need pieces Base-A, Base-B, and Base-C Put the now fully-assembled base level aside for the moment. Assembling level 1 For… Read more
Below is a painting guide, explaining the steps taken to paint Ironhelm Fortress. The model was initially primed with matt black primer. Stone This is the scheme used for the bricks and stone. Heavy dry-brush: Army Painter Dungeon Grey. Lighter dry-brush: Army Painter Ash Grey. Final highlight: Army Painter Arid Earth. Trim This is the… Read more
Below is a painting guide, explaining the steps taken to paint The Temple of the Damned. The model was initially primed with matt black primer. Bone This is the scheme used for the skulls, bone edging and teeth on the roof. Heavy dry-brush: Army Painter Leather Brown. Lighter dry-brush: Army Painter Barbarian Flesh. Wash:… Read more
Elwira Pawlikowska has worked as our concept artist since 2015. After graduating from Warsaw Faculty of Architecture Elwira works as a freelance illustrator and designer with a special fondness for environment/architectural designs. She specializes in medieval and steampunk styles, however she doesn’t limit herself only to these two.She finds inspiration in works of Old Masters,… Read more
Below are the scale reference guides for the models showing their sizes in relation to other models in their corresponding ranges. Dwarven scale reference Elven scale reference Demon scale reference
This is a video showing some different ways to configure the Elven Groves OpenLOCK scatter terrain. There are 16 pieces in this set. Included are 5 corner end pieces, as well as 1″, 2″, 4″ and 6″ length walls, and a 3″ doorway that grant a wide variety of wall configurations. There are also… Read more
This is a video showing some different ways to configure the Caverns of Torment OpenLOCK scatter terrain. There are 14 pieces in this set. Included are 5 corner end pieces, 1″, 2″, 4″ and 5″ length walls, as well as 45- and 90-degree curves. There are also S curve pieces to make “snakelike” walls…. Read more
Here is the list of parts required (per level) to create the Large Square Tower.
This is the list of parts required (per level) to build the Round Tower with Buttress.
Horizontal OpenLOCK ports print with small supports to support the overhangs in the port mouth. You need to remove these supports post-printing before you can insert the OpenLOCK clips. We recommend using some needle-nosed pliers for this task. You can use the pliers to grip and twist the two supports in each port, breaking them… Read more
