Description

Hiding behind a ‘Rock’ is a great tactic often used to prevent oneself from being shot.

Updates:

8 May 2018 – 1.0 Base of rocks connected together to enable easier printing.

Notes for Stackable Rocks:

Right-click on the image below and “Save As” to download the reference sheet for this pack.

Additional information

Recommended Printer	FDM or resin printer
Infill	100% for resin printing, 10% to 15% for most parts but increase to 20% for thin upright parts such as door frames for added strength
Layer Height	0.05 high quality on resin printers, .2 for Normal Quality .1 for High Quality (.2 Layer height is recommended)
Supports	requires supports for resin printing, Prints without Supports
Raft	Switch raft ON to help print bed adhesion
Scale	28mm Wargames

Use this tool to find the percentage needed to scale your model up or down when printing.
The highlighted row shows the model's current scale and other rows show what percentage to print at to reach that scale.
To set a custom scale, use the calculator in the bottom row.

Name	Millimeters mm	Ratio	Scale %
10mm Wargames & N Scale	10	1:159	35.7%
15mm Wargames	15	1:116	53.6%
HO Scale	20	1:87	71.4%
OO Scale	22	1:76	78.6%
28mm Wargames	28	1:62	100.0%
32mm Heroic & OpenLOCK	32	1:54	114.3%
			-

mm is the height based on the measurement from the bottom of the feet to the eye height of the average human
Height is not the same as Base Size (A 28mm miniature will often have a 25mm round base)

Comments

Brandon Woodward (verified owner) – May 2, 2018

What would you suggest as a brim size for this?

Printing rocks 02 and 03, first with no brim and all the outer column pieces fell during printing.
Printing again now with a 3mm brim which seemed to do well except for one piece on rock 02, one edge piece has fallen over mid print.

Trying to find a good middle ground of brim size and using least material possible.
- Matt Barker – May 2, 2018
  
  If you use a raft it will help with bed adhesion