Description

The Earl’s Tower loomed over the rest of the Kingdom, a fortified spear stabbing into the sky. The combination of turrets, crenulations, and sheer height made it a bastion all on its own. The invaders would need more than sheer numbers if they wanted to take this tower.

Find out about how to use SystemHEX in our article here.

Our paint guide for castle bricks is here, and painting Wattle & Daub and Roof tiles is here. Check out this article here for tips on printing Throne & Ash models.

See below how the HEX Castle Earl’s Round Tower tessellates with the Castle Walls.

3D top down render of adeline tower

Notes for 3d Print file:

Right-click on the image below and “Save As” to download the reference sheet for this pack.
Where buttresses are placed, the flat wall plug will need to be used underneath.
Product measurements can be found in the image gallery.
First Published version 1.3

Earls Round Tower Reference

Adaptors, Ladders and Buttress Reference

Earls Round Tower Reference

Additional information

Recommended Printer	FDM or resin printer
Infill	10% for FDM printing, 100% for resin printing
Layer Height	.2 for Normal Quality .1 for High Quality (.2 Layer height is recommended)
Scale	32mm Heroic & OpenLOCK
Supports	requires supports for resin printing, FDM Prints without support, Requires supports on some files, Resin Pre-support included in the download.

Use this tool to find the percentage needed to scale your model up or down when printing.
The highlighted row shows the model's current scale and other rows show what percentage to print at to reach that scale.
To set a custom scale, use the calculator in the bottom row.

Name	Millimeters mm	Ratio	Scale %
10mm Wargames & N Scale	10	1:159	31.3%
15mm Wargames	15	1:116	46.9%
HO Scale	20	1:87	62.5%
OO Scale	22	1:76	68.8%
28mm Wargames	28	1:62	87.5%
32mm Heroic & OpenLOCK	32	1:54	100.0%
			-

mm is the height based on the measurement from the bottom of the feet to the eye height of the average human
Height is not the same as Base Size (A 28mm miniature will often have a 25mm round base)

Comments

joshua.rouleau (verified owner) – October 14, 2025

A bit disappointed in the modularity of the top three levels (the ones above the battlement). Would have liked the wattle and daub level to be a standard level size so you could use it for other levels, and there to be a one piece roof option that could go above the battlement but not need the wattle and daub middle layer. Happy if those options are coming out in a later kit (maybe Fort Bruce?).
- Matt Barker – October 15, 2025
  
  We could eventually do a medium tower that goes to the small tower on top, a good update to the medium tower for sure. Its always a balance between artistic style and modurlaty.
kagbb (verified owner) – November 1, 2025

the round buttress and plug, could we get versions that fit a square tower?