Inn of the Welcome Wench

So I am wrapping up the Inn of the Welcome Wench on the Roof printing now and I am about a third through. I am seriously concerned on the portion that juts out. I have its roof and what should be the connecting roofs but if I align the smaller section over the Corbel overhangs it does not cover the entire smaller section. there is a small gap. When I add the connecting section of the main building aligned to the overhanging with the corbels and there is a half-inch gap.

I included a picture.

Unless I leave the corbels sticking out of the side of the smaller section or somehow the rest of the roof pushes to go beyond its corbels I will need to reconfigure the smaller areas roof.

• This topic was modified 5 years ago by Brian Etty. Reason: side view
• This topic was modified 5 years ago by Brian Etty. Reason: side view