Description
“sheltering from the rain under the vast arch, the old sellsword leaned against the crumbling stonework. Once this had been a grand entrance to the city, now it was no more than another slum in the urban sprawl.”
Updated:
- 3 June 2021 (version 1.3) Support version for Lv1 Bottom now included.
- 16 November 2021 (version 1.4) Small printer cuts added.
- 26 May 2022 (version 1.5) Ruined-Entrance-Gate-Lv2-Top had a thin layer repair.
Notes:
- Right-click on the image below and “Save As” to download the reference sheet for this pack.
- Product measurements can be found in the image gallery.
- First Published version 1.2
David Aleshire –
This is so cool, I love this, any chance you might add a non ruined version of this to clorehaven or winterdale? I really love the tunnel on bottom and the stone walkway that juts out. I would love non ruined versions of some of these models like bell tower and Sept as well as both wings of the gatehouse!
Nicholas Jebson (verified owner) –
Thanks for the suggestion. This might be something we can do as an add-on set in a future kickstarter.
Hayden Roslansky (verified owner) –
Great looking model! Will work perfectly for my pirate shanty town encounter I’m planning for my group. One quick question, do I need to ensure “make overhangs printable” is selected in Cura when printing the “Level 1 bottom” file? The part I’m concerned about is the balcony arch, just don’t want too much spaghetti stringing underneath! Thanks again guys, these models are incredible, my group loves when I drop these things on the table!
Mike –
Hi Hayden!
Thanks, we’re glad your group likes them too! An update with a pre-supported version should come out in the near future. We appreciate your suggestion immensely!
brendon.techie (verified owner) –
Any chance you can add a flat layer to the bottom of the 1st Floor Bottom? (Ruined-Entrance-Gate-Lv1-Bottom_v1.1). The Tiny cracks in the wooden floorboards keep lifting or catching. It’s not hard to cut away a thin layer afterwards with an exacto knife, so that would be preferable.
Mike –
Hi Brendon,
Have you tried printing it with a raft for build plate adhesion? That should sort out your issues no problem.
Just in case try turning up the temperature of your build plate to increase adhesion if they’re lifting off during the printing process. Try between 60-70 degrees and they shouldn’t warp off.
Hope that helps and happy printing!
robert.a.crozier (verified owner) –
Are there any ruined wall sections that pair with this gatehouse? If not, that could be good in an add-on, to make it like a whole ruined city wall with corner sections and towers and everything
And I also think it would be cool to have a non-ruined version of the whole entire Feywild town
Mike (Printable Scenery) –
Hi Robert,
Thanks for sharing your ideas! There isn’t a wall section it lines up with, the idea is that they built houses on top of it. A future ruined parapet would be cool though!