Description
The archers rained arrows on the invaders from the protection of their battlement. The recently painted red wooden pavises mounted on the walls ensured that few arrows came back across. It had only been a few minutes, and already they could see the invaders will breaking, fewer daring to run at the walls. One of the archers paused and gazed up. “Don’t stop, boy, we have them!” cried the captain, just as the boy was blown off the wall in a shower of bricks and debris and shattered red wood.
Find out about how to use SystemHEX in our article here.
Our paint guide for castle bricks is here. Check out this article here for tips on printing Throne & Ash models.
Notes for 3d Print file:
- Right-click on the image below and “Save As” to download the reference sheet for this pack.
- Small Printer Reference sheet is included in the zip file.
- Product measurements can be found in the image gallery.
- First Published version 1.3
Mark Luce –
I’m not sure if this is possible, but could we look at splitting the wall into two pieces, being the main structure and the top, that way we can swap between Bowman Battlements or normal without reprinting the whole wall.
Joanne Boorer (verified owner) –
We will look into this as an option but may not look good aesthetically.
Roem (verified owner) –
will there be a short wall version?
Joanne Boorer (verified owner) –
We will add this to our updates list as we had not originally planned to do a low wall option.
torbjorn.andersson (verified owner) –
Is there a T-junction available or perhaps planned to be?
If you want to extend a wall between two wall pieces.
Joanne Boorer (verified owner) –
We have the new Milbury coming up for release. You will be able to create a T-section using this Lv1.