Library of Ithillia – yes/no to supports?

[ZN]

Just started Library of Ithillia and am disappointed as this is sold as supportless, but pretty sure this will need support (2FL-B)- or am I missing something? 🙂

Attachments:

1. 

   support.png
   

[Nicholas Jebson]

Hey ZN! you should be fine printing it without supports, though as they are quite small you could add the supports just to be sure. Its been quite a popular print and we haven’t had feedback to the contrary that it was an issue, and our own one printed fine without.

[ZN]

Thank you! Good point – so I’ll give it a shot.

[Nicholas Jebson]

When its done you should definitly show it off!

[ZN]

I should have believed the science 😉 I was brainwashed by your high popularity! hehe
One simply cannot print in thin air, no matter how small the edge. This needs support 🙁

Attachments:

1. 

   ps.jpg
   

[Nicholas Jebson]

Right, we will have to update the piece to reflect this. Thank you for your response.

[Author]

Posts