assembly problems

[silverleaf79]

I have printed all my pieces to assemble the homestead building but when I go to put the clips in after removing all the outer supports my support for the clips break when I put my clips in what can I do to prevent this it has done it on every floor and wall piece

[billremig]

I print my clips at 98% size, to prevent such a tight fit as to break the clips or channels. If you are printing your clips at full size, I’d recommend trying that. If you are already printing them at a reduced size, the printer needs to be calibrated.

[silverleaf79]

thank you ill try reducing the size of them I have been printing them at 100%

[dougal.scott]

I found that when I hadn’t levelled the printer properly the resulting elephants feet would cause that issue.

See https://all3dp.com/2/elephant-s-foot-3d-printing-problem-easy-fixes/

[Author]

Posts