Reply To: Problems with A-Wall-Schist-v0.2

[darkangelxx511]

Mike –
No problem! Just FYI, we are printing out the Inn of the Welcome Wench using your guide. We’ve completed the cellar portions of the build, with the exception of this file. Everything else has printed just fine, it’s just this one file. We’ve tried on our Prusa and Dremel, so I’ve attached both slicer settings for you. The Prusa is extensive, but, I didn’t know exactly which slicer settings you needed, so, I screen shot them all. Thank you so much!

Attachments:

1. prusa-settings.pdf
2. Dremel-Settings-Printable-Scenery.pdf