Cart (0)

Reply To: First Print Troubleshooting

Home Forums Resolving 3D Printing Problems First Print Troubleshooting Reply To: First Print Troubleshooting

#229025
MattMatt
Participant

Your print head is too high and the filament is not adhering to your bed. You need to adjust your bed up until you can’t see gaps between the lines on the brim. You can use some of the settings from this profile as well will help especially with doing a magic first layer which is hotter and slower which sticks better. Also consider getting some hairspray for adhesion. https://www.printablescenery.com/2020/01/21/creality-ender-3-cura-4-4-1-settings/

©2022 Printable Scenery. Website by Vienna & Bailey