This week was another good week for releasing models, with four new Throne & Ash products going live. We got another wall option made, which uses adaptors to create horseshoe walls. We added the battlements, which are perfect for creating defensible junctures along your wall. We also added two models to the castle grounds with… Read more
With Throne & Ash, not only can you use the SystemHEX design to build sprawling castles, you can also build amazing 3D printed scatter terrain perfect for wargames. In this article, we’ll show you how to turn basic walls, buildings, and ruins into immersive and engaging boards for skirmish wargames, like Mordheim, Malifaux, and Star… Read more
This week, we got back on track with our schedule, releasing both the Ruined Wattle & Daub Tower and the Ruined Wattle & Daub Living Quarters. They’re some of the most detailed models from Throne & Ash yet, with heaps of playable interiors and piles of ruins with flat tops where you can place your… Read more
We’ve had a couple of weeks to iron out kinks and roll out updates to several products. Thank you for your support and for helping us continuously improve our products. Over the past two weeks, we’ve updated the Wattle & Daub Living Quarters roof on the barracks side to fit the chimney buttress. We’ve added… Read more
We’ve had another action-packed week of updates and new models. We added new sunken debris options for the Wreck, we added fireplaces without fires for the ruined Queen’s Quarters, we updated the Castle Gatehouse with a windlass for the iron bars, added a new Norman wall end, and added low versions of the Castle Wall… Read more
In this article, we’ll show you how to assemble your 3D printed Throne & Ash doors in a few straightforward steps. We’ll show you how to clean up the parts, fit them together, and check that it’s working. You’ll have functional doors throughout your castle in no time, perfect for when players need to sneak… Read more
We’ve had a week of small updates with big impact. We added an infill block to raise the stairs to a higher level, we made a combined level 1 floor for the King’s Keep, making it a huge playable area, and we added a level 2 trap door on the barracks. This week, we also… Read more
In this article, we’ll cover a few basics and tips for 3D printing Throne & Ash models. We’ll cover the printer and settings we’re using, give some tips on smaller models, and give some tips for laying out models on your printer bed. Basic 3D printer settings tips We’re using Bambu Labs P1P 3D printers,… Read more
Hey everyone, the dust is beginning to settle after the end of Throne & Ash, so we’re in full swing with releasing the stretch goals. We launched five of the first stretch goals last week, and this week we’re releasing three more: the Ruined Queen’s Quarters, the Wattle & Daub HEX Tower, and the Castle… Read more
With the release of the Queen’s Quarters, we thought we’d show how to build a castle called Castle Agnes using the model and some of the other new models from this week. This one’s a bit more of a complex build and uses a wide variety of models from Throne & Ash. To show you… Read more
