Viewing 2 reply threads
- The forum ‘Model ideas and update suggestions’ is closed to new topics and replies.
Tagged: Clorehaven
Hello,
There are some overhangs in the piece “A-TudorFirePlace-v1.1” that are causing prints to fail. I’ve tried a few times now and it consistentenly comes loose form the print bed. Now, before you think it’s my adhesion let me say that I print a LOT and never have problems. In this case a “booger” forms which the nozzle bumps into on the next pass, and game over.
Could you update the piece to reduce the overhangs a bit please?
The issue is highlighted in the screen shot.
Thanks in advance!
Interesting enough I just saw this update note on the product page:
“29 January 2020 (version 1.3) Overhangs fixed in the A and AS fireplaces.”
I have the 1.3 version downloaded but it contains 1.1 fireplaces??
Hey Fedday, We will look into it, as it should be fixed by now
We use our own and third-party cookies to personalize content and to analyze web traffic.
Required cookies only Accept cookies