Cart (0)

Floor tiles curve not flat

  • Author
    Posts
  • #187173
    Avatarjohnlaw13
    Participant

    Hi looking for some advice I have printed a few of the floor tiles from clorehaven and when I add the clips and click 2 together they both float at the opposite ends looking for any advice to fix or make it less noticeable thanks

    #187261
    Avatardougal.scott
    Participant

    If you haven’t dialled in your printer perfectly you may be getting elephants feet on the tiles, which would make them not sit flat when you stick them together.

    If you feel along the bottom edge of the tile (the one touching the print bed) if you feel a slight ridge then you have this problem.

    You can solve it on printed tiles by judicious use of a file or a craft knife, and you can fix your printer using the instructions in https://all3dp.com/2/elephant-s-foot-3d-printing-problem-easy-fixes/

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
©2020 Printable Scenery. Website by Vienna & Bailey