Cart (0)

Cura slicing error

Tagged: 

  • Author
    Posts
    • #140995
      Avatardavidlmosely
      Participant

      I keep getting little zits and blobs in my test prints and now think it may have something to do with the way cura slices the files. I’ve already dialed in all of my retraction setting etc and no matter what I change they show up in every print, in the exact same spots. After looking at the layer view in cura it turns out it is intentionally printing them. It seems to just add a few spots out in space and I cant figure out why. You can see what I mean on the example, it’s the dog house I’ve been using as a tester. Has anyone run into this?

      Attachments:
    • #146170
      AvatarFern Campbell
      Participant

      Hey there,

      I know this is an old post, but I’m just jumping into these forums for the first time today. Have you tried turning on Coasting in the Experimental section of Cura?

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
©2020 Printable Scenery. Website by Vienna & Bailey