Cart (0)

Clips not fitting?

Tagged: ,

  • Author
    Posts
    • #296705
      AvatarIsaac Helmuth
      Participant

      Hello, I printed out several of the floor tiles and clips (no walls yet) and the clips seem too small to fit around the receptacle.

      I did not change the dimensions in my slicer.

      The prongs of the clip stretch too far to insert fully.

      Am I doing something wrong?

      I am using a resin printer if that makes a difference.

    • #296731

      Hi Isaac,

      Theres actually an in-built support you need to remove for the clips to fit.
      We’ve got an article in our knowledgebase here that will show you:

      Removing supports from the OpenLOCK ports

      Hope that helps!

Viewing 1 reply thread
  • The forum ‘Resolving 3D Printing Problems’ is closed to new topics and replies.
©2022 Printable Scenery. Website by Vienna & Bailey