6×6-TRP-Roughstonefloor question

[Peivalke]

Was thinking about printing a few of these up. The middle looks hollow, how much infill should I use for this tile or does it not need it?

[Brian Etty]

I tend to keep mine at about 10%. I did find that I printed them above .2 and had some minor gaping on the floor. So I would say that is the more important setting. I would not go above 20% as it would be a complete waste. Still going to use them as I can add some goop and all will be good.

[Matt]

You can increase the top and bottom layer height if you need to compensate for your infill.

[Author]

Posts