Cart (0)

Reply To: Globs on Top of Wooden Floor Tile

Home Forums Resolving 3D Printing Problems Globs on Top of Wooden Floor Tile Reply To: Globs on Top of Wooden Floor Tile

#331176
AvatarHolly Tyminski
Participant

I’m using Anycubic Grey PLA, which is 190-230. I have it set to 200. Maybe I should adjust the extruder then? Can I change something in Cura to say not to extrude so much on the top layer?

©2022 Printable Scenery. Website by Vienna & Bailey