Cart (0)

Reply To: Globs on Top of Wooden Floor Tile

Home Forums Resolving 3D Printing Problems Globs on Top of Wooden Floor Tile Reply To: Globs on Top of Wooden Floor Tile

#331168
AvatarNicholas Jebson
Participant

Your hot end might be running a little too hot. Sometimes it can extrude too much material when the temperature is higher than needed, resulting in these little extra blobs of filament where they are not meant to be. I would check the manufacturer’s specs for the specific filament you are using and making sure its within 5 degrees or so of that.

©2022 Printable Scenery. Website by Vienna & Bailey