Cart (0)

Reply To: printing on a cr-30

Home Forums Resolving 3D Printing Problems printing on a cr-30 Reply To: printing on a cr-30

#275909
Avatarneroes
Participant

so you might be able to do it but i honestly don’t see being pritty, the belt while fairly tight is a textile so printing tall thin objects seems foolish, i have however noticed that the bottom layer of the tile is a tad bit shorter than some of the other tiles i have printed
the ones printed on my creality CR-30 is the cave floor and i have some old mine floor tiles printed on a prusa mk3S
will send a picture later

btw. there is a noticeable difference in surface smoothing when printing flat on both machines, it looks nicer on the cr-30 due to the layerline being at a 45 degree angle

©2022 Printable Scenery. Website by Vienna & Bailey