Cart (0)

Reply To: Branches failing on print (Ender 3 V2)

Home Forums Resolving 3D Printing Problems Branches failing on print (Ender 3 V2) Reply To: Branches failing on print (Ender 3 V2)

#270931
Nicholas Jebson
Participant

Usually knocking is the major cause of branch failures, like can be seen on the one center-right where it has detached lower down. if you slow the print speed a little and up your retraction settings during travel to minimise the chance of knocking the model that should help

©2024 Printable Scenery. Website by Vienna & Bailey