Cart (0)

Reply To: Unwanted infill on Openlock?

Home Forums Resolving 3D Printing Problems Unwanted infill on Openlock? Reply To: Unwanted infill on Openlock?

#257930
Nicholas Jebson
Participant

Hey Leynok. It looks like you have support settings turned on, The Openlock tiles print without the need for them. When your in the slicer if you look for your support settings (usually on the right hand side in Cura) and untick generate supports that should solve it for you

  • This reply was modified 3 years, 4 months ago by Nicholas Jebson.
©2024 Printable Scenery. Website by Vienna & Bailey