Home › Forums › Resolving 3D Printing Problems › Infill issue with schish walls/battlements › Reply To: Infill issue with schish walls/battlements
September 22, 2020 at 10:01 pm
#233960
Participant
Hi Dehmlowm –
The problem is not with the models it is with PrusaSlicer. For some reason it creates a partial internal ceiling for every row of blocks – where the line of mortar would be between the rows in a real wall.
Cura does not do this and produces much faster prints. Also, I recommend that you print with a brim, particularly the very narrow/tall pieces. As you can see from the attachment there is no extraneous infill or ceiling.
Regards,
Nick
-
This reply was modified 3 years, 2 months ago by
Nicholas Strugnell.