Cart (0)

Reply To: Infill issue with schish walls/battlements

Home Forums Resolving 3D Printing Problems Infill issue with schish walls/battlements Reply To: Infill issue with schish walls/battlements

#231730
AvatarNicholas Strugnell
Participant

Just to follow up on this, I decided to go with the Cura gcodes in the end as even dropping the horizontal shells in Prusaslicer it still generated loads of internal ceilings. The Cura gcodes are using about the half the amount of material (with a concomitant decrease in print time).

©2022 Printable Scenery. Website by Vienna & Bailey