Home › Forums › Resolving 3D Printing Problems › Ender 3 hanging strings › Reply To: Ender 3 hanging strings
March 31, 2020 at 10:32 am
#195957
Participant
Yes, in Cura there should be a section called “Fillament Settings” where you can set it to the manufacturers recommended tempreture, then when you go to print it will register the tempreture settings from there.
We have also gone over the model and found that there is a slight overhang that can also be causing the stringing that we are going to get sorted. Thankyou for bringing it to our attention!