Cart (0)

Reply To: General Printing Settings Guidance

Home Forums Resolving 3D Printing Problems General Printing Settings Guidance Reply To: General Printing Settings Guidance

#194551
Matthew Horbund
Participant

Ok, once i figured out the 6 “bars” on the outside of the floor and wall are your built-in support and they get removed, the clips fit. Now I need to reprint everything I broke. and i broke a LOT 🙁

For newbs like me, is there a step-by-step “this is how we do it” for the most recent versions? It would have been fantastic to see
Step 1 – use a needle nose plier to pull out “these supports” with a picture
Step 2 – Slide the clips in, you dont need more force than it would take to crush coal into a diamond
Step 3 – keep doing it til you’re done

🙂

©2024 Printable Scenery. Website by Vienna & Bailey