Home › Forums › Resolving 3D Printing Problems › General Printing Settings Guidance › Reply To: General Printing Settings Guidance
New to these files, and looking forward to getting and printing more. Having a devil of a time with clips snapping and not working even with all the recommended setting.
Curious if everyone is printing floors horizontal (flat on bed) or vertical. I found flat on the bed the tops (stone side) are indistinguishable. However standing them up they look fantastic, like walls.
I’m using a Raise3D N2 with a 0.4mm nozzle, 0.2mm layer height, 4 top and bottom layters, 3 shells/perimeters, 15% grid infill. Just need to figure out how to get clips in without snapping them or the tiles.
-Matt
@potent3d (was @Jet_Prints)
@mmWine