Cart (0)

Reply To: Church wall end piece problem

Home Forums Resolving 3D Printing Problems Church wall end piece problem Reply To: Church wall end piece problem

#174059
AvatarFenriswolf
Participant

I was printing them one at a time to figure out why I had a problem. Someone of FB recommended printing them four at a time but spacing them across the print bed. He figured that sometimes working on smaller pieces does not give the layers time to cool off and they lift up and hit the nozzle. He also recommended using a brim. I took his advice and was able to print off both versions of the wall ends. Thanks everyone.

©2022 Printable Scenery. Website by Vienna & Bailey