Home › Forums › Resolving 3D Printing Problems › Church wall end piece problem › Reply To: Church wall end piece problem
October 18, 2019 at 4:31 am
#173755
Fenriswolf
Participant
I will try to adjust the zhop setting. I don’t think it is an adhesion issue. I have successfully printed all of the other files without a single problem. When in the final stage of printing the two end pieces, the nozzle literally goes into an already printed area which either dislodges the piece or creates a spot where the filament comes out in a glob. Hard to explain, sorry. But thanks for the advice.