Cart (0)

Reply To: 6×6-TRP-Roughstonefloor question

Home Forums Resolving 3D Printing Problems 6×6-TRP-Roughstonefloor question Reply To: 6×6-TRP-Roughstonefloor question

#147217
AvatarBrian Etty
Participant

I tend to keep mine at about 10%. I did find that I printed them above .2 and had some minor gaping on the floor. So I would say that is the more important setting. I would not go above 20% as it would be a complete waste. Still going to use them as I can add some goop and all will be good.

©2022 Printable Scenery. Website by Vienna & Bailey