Reply To: Profile for Prusa i3 Mk3 – Sli3er

[azyre1]

I’m using eSun Pro grey, 10% infill at .15 speed and getting VERY good results. First layer is @ 220 with the rest @ 200 and the board at 60 (I think the box states 220-260 so I’m way below rec on that). I’m in Florida and it’s crazy humid here but the setting work very well.

I’m having first layer layer shift problems but it’s consistent so I’m fairly certain that’s a hardware issue I just can’t track down.

• This reply was modified 5 years ago by azyre1.