Cart (0)

Reply To: Problems printing Gloomwood Eyrie

Home Forums Resolving 3D Printing Problems Problems printing Gloomwood Eyrie Reply To: Problems printing Gloomwood Eyrie

#138983
Avatarp_comins
Participant

I dropped the travel speed from the stock 120m/s down to 100m/s in Cura after reading elsewhere that may help.
And it did… until the very top of the balustrades when I had no less than 5 break off in quick succession about 2 layers before they all join at the top.. makes it a little more salvageable than my prior efforts – so changing that setting may help others.

©2022 Printable Scenery. Website by Vienna & Bailey