Cart (0)

Reply To: Problems printing Gloomwood Eyrie

Home Forums Resolving 3D Printing Problems Problems printing Gloomwood Eyrie Reply To: Problems printing Gloomwood Eyrie

#138793
Avatarp_comins
Participant

I concur. (Printing on an Ender 3 using Cura 3.6). Thickening would help a lot. I’m printing double walls (.4 nozzle @ .16 layer height) with an additional wall every alternate layer (which helped with the Winterdale Wizard Tower where the balustrades were similarly frustrating breakage-wise) Oddly the internal window struts which are equally thin or thinner printed fine… just not the balustrades around the edge…

©2022 Printable Scenery. Website by Vienna & Bailey