Cart (0)

Reply To: General Printing Settings Guidance

Home Forums Resolving 3D Printing Problems General Printing Settings Guidance Reply To: General Printing Settings Guidance

#136062
Matt
Participant

We use only Prusa I3 mk3, with a .4mm nozzle, exclusively at the moment, Usually each product we release has the recommended print settings in the additional information.

Typically our baseline for buildings for print settings is 0.2, with 10% infill.
I usually put glue on the print bed and print with a raft to alleviate lifting at the edges with large prints.

©2024 Printable Scenery. Website by Vienna & Bailey