-
AuthorPosts
-
-
November 17, 2021 at 5:20 am #312215
mike.mccreery
ParticipantHere is a proportional layout for the dungeon level below the Ruins of the Moathouse in the AD&D module T1 The Village of Hommlet.
Attachments:
-
November 17, 2021 at 5:23 am #312217
mike.mccreery
ParticipantI surrounded the walls in foam to give the impression of the map being underground.
Attachments:
-
November 17, 2021 at 5:36 am #312222
mike.mccreery
ParticipantSome of the walls for this setup are 2 dimensional. I had to account for the difference. Any wall running the full length of the dungeon can be disregarded for the purposes of keeping the dungeon proportional. For example the exterior walls are automatically disregarded. Any partial walls inside the structure have to be accounted for in places they dont exist. So, I put in a spacer in the same location where these situations occur.
This means the dungeon is slightly larger than the map but over the scale of this dungeon it may be 1″ wider and/or larger but all the rooms and hallways still line up properly and the party can follow a module map.
Attachments:
-
November 17, 2021 at 5:40 am #312224
mike.mccreery
ParticipantPainted the walls with a gloss to simulate moisture.
Attachments:
-
November 17, 2021 at 8:22 am #312236
Mike Los
ParticipantLooks great!
I really like the use of the foam blocks to set it in the ground.
Well done!
-
-
AuthorPosts
- The forum ‘3D printed terrain for Dungeon Masters’ is closed to new topics and replies.