Cart (0)

Shrine of Solace painted

  • Author
    • #183996

      Hello all

      Here is my attempt for the Shrine of Solace

      Printer: stock Ender 3, 0.2mm, 15h, Amazon PLA, 5% infill

      Paint: basic acrylic + some shades and contrast from GW + moss (mix old old GW one + railway moss).

      Modification: fine sand on some flat surfaces to get a proper drybrusing + some acetone on some tiles to smooth them

      The goal is to create a place for invocations (and it’s also perfect for Playmobil Elves according to my daughter). It’s a little bit too large for “true 25 or 28mm”.

    • #184992

      Good paintjob, The extra sand is a nice touch.

      • This reply was modified 4 years, 5 months ago by Matt.
Viewing 1 reply thread
  • The forum ‘Painting 3D printed models’ is closed to new topics and replies.
©2024 Printable Scenery. Website by Vienna & Bailey