Cart (0)

Problems finding prints in the Prusa Slicer

Tagged: , ,

  • Author
    • #150961

      I have been printing with a Tevo Tarantula and got a Prusa MK3 I3S. I was slicing with CURA and switched over to the Prusa Slicer but I cant see the files in the Prusa slicer. Any suggestions? Lord knows I didn’t explain it right so please have pity on a newb.


    • #150985
      Sam CampbellSam Campbell

      You might be in the wrong view tab. There is 3d Editor view and Preview (only shows here after you slice it)

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
©2021 Printable Scenery. Website by Vienna & Bailey