Printspeed and walls

[Michael Lundstedt]

Hi,

Two questions here.

1: What is the difference between an A and B wall (heavy walls)? Is it just to add variety?

2: Would it be possible to print the lower half of walls and floors (connector area) at 0.25 DRAFT to save time or would the tolerances be too bad for good connection?

BR
Michael

[Nicholas Jebson]

You should be able to print at a 0.25 though the rate of error will increase a bit. We know people who have printed at a 0.4 draft and they have come out. The difference was what side of the wall the OpenLOCK port was located on. B walls are now a legacy thing as they were superseded by the triplex A wall that has ports on both sides of the wall.

[Author]

Posts