Cart (0)

Connecting Ship Pieces

  • Author
    Posts
  • #170848
    Avatar
    andrew6
    Participant

    I’m in the middle of printing out a Galleon (my first large ship after a single print sloop) and I can’t figure out the best way to connect the pieces. I see the holes printed in the connection edges but I don’t see any connectors for them in the set. Are they somewhere else on the site like the openlock clips or do people just glue them together?

    #171714
    Sam Campbell
    Sam Campbell
    Keymaster

    You can use filament or wire to line up the pieces to hold in place while glue dries.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

©2019 Printable Scenery. Website by Vienna & Bailey