My Account 
I do apologize Brian for not getting back to you sooner, we were all hands on deck last week to get the kickstarter off the ground.
We have had a look at our built version out the back and we are struggling to see any difference between the two builds, except our one does cover the gables. We are putting it down to spread from some of our clips not embedding fully and giving ever so slight gaps in some of the roof sections, which add up over such a large print. We did also have 9 separate printers going to create it so any discrepancies in brims may have also played a factor. The only solution we can see in the office in the interim is to take the end cap A sections (the 1/2″ ones) and alternate them facing either direction to lock them together.