Cart (0)

Reply To: Resin Printing, Cost, Tips and a getting started guide

Home Forums Getting Started Resin Printing, Cost, Tips and a getting started guide Reply To: Resin Printing, Cost, Tips and a getting started guide

#230277
AvatarWilliam Oakley
Participant

Thanks for this! I couldn’t figure out why pieces were warping at the bottom.
Here is a new issue I’m seeing. I’m using an elegoo Mars, I hollowed out the wall segments as instructed, added a drainage hole, double checked supports, but after curing, every single piece has cracked along the bottom.

Curing too long?

©2022 Printable Scenery. Website by Vienna & Bailey