Cart (0)

Reply To: Infill suggestion for solid buildings?

Home Forums 3D Printed Terrain for Tabletop Wargames Infill suggestion for solid buildings? Reply To: Infill suggestion for solid buildings?

#176705
AvatarDeVoice
Participant

Depends on your printer and printer settings. By setting to a low infill means that longer bridges will be made. So whether layers will sag (areas soley lying on infill for support like ceilings) is dependent on your setup unfortunately. I would suggest print a test piece. Otherwise I would recommend 10%.

5% will mean that it prints slightly faster, but you lose weight and rigidity, so it’s up to you.

©2022 Printable Scenery. Website by Vienna & Bailey