Cart (0)

Reply To: Anycubic I3 Mega

Home Forums Recommended Printers and Printer Reviews Anycubic I3 Mega Reply To: Anycubic I3 Mega


All of my terrain has been done on it. The biggest piece of advice I can give for it is to do the sheet of paper alignment when the extruder and heat bed are cold, it seems to factor in expansion due to heat automatically.

Most of mine has been print in .2mm layer height, 10% Cubic Subdivision infill. I’ve had some bad luck with horns or teeth on buildings breaking, but that’s only due to a fall off of a table landing in the worst possible way.

©2024 Printable Scenery. Website by Vienna & Bailey