Cart (0)

Reply To: Sorcerer's Tower

Home Forums Model ideas and update suggestions Sorcerer's Tower Reply To: Sorcerer's Tower


Level 2 Part 1

Just finished printing up this piece and the corbels are very weak. Could be my printer settings, but it seems there isn’t a lot of structural strength to them. I barely put pressure on two of them and they snapped off. Checked several others and they were wiggly and looked like they would break any minute. I broke out my Bondic pen and reinforced all of the connections with resin. Seems like it should hold for now. Otherwise, it is a beautiful piece. The levels are fitting together perfectly I am very excited to start painting this.

©2024 Printable Scenery. Website by Vienna & Bailey