Cart (0)

Reply To: Cosmic Gate – supports yes or no?

Home Forums Getting Started Cosmic Gate – supports yes or no? Reply To: Cosmic Gate – supports yes or no?

#211977
AvatarNicholas Jebson
Participant

The Artillery i would assume still uses Cura, so i would use the same Cura profile as seen above but when selecting a printer you just have to make sure that the bed size is the same as the X1 (300mm * 300mm * 400mm) so that there is no chance of attempting to print outside the buildplate. You can do this either by selecting a custom printer or another printer with the appropriate size.

©2022 Printable Scenery. Website by Vienna & Bailey